GE JVM6175SKSS Microwave Problems & Error Codes — Overview
The GE JVM6175SKSS is an over-the-range microwave that shares the standard GE microwave fault-code table, including F1 through F6, F10, Probe, 888/8888/PF, and 18 power watch codes. The most frequent service calls on this platform involve thermal sensor failures (F1 and F2), touch panel shorts (F3), and probe-related errors during temperature cooking functions. Field experience shows that sensor and wiring issues account for the majority of fault codes, often triggered by poor connector contact, moisture intrusion, or genuine overheat conditions from blocked ventilation.
Most Common Problems on This Model
- F1 code (open thermal sensor) An open or disconnected cavity thermal sensor, failed sensor wiring, or poor connector contact triggers this code and the sensor or harness needs replacement.
- F2 code (shorted thermal sensor) A shorted thermal sensor element or wiring short causes this fault and requires replacing the thermal sensor after confirming the short with an ohm check.
- F3 code (shorted touch pad) A failed membrane keypad, stuck keys, or moisture damage in the control panel creates a short and the touch pad assembly must be replaced.
- Probe or F6 code during temperature cooking An unplugged, open, or shorted temperature probe (or damaged probe jack) throws the code and the probe assembly should be tested and replaced if it fails continuity checks.
- F4 or F5 humidity sensor codes An open (F4) or shorted (F5) humidity sensor or broken sensor lead causes the fault and replacement of the humidity sensor resolves it.
- 888, 8888, or PF display after power interruption A power loss or startup condition leaves the display showing these codes and pressing Cancel/Off or Clear/Off clears the display and allows clock reset.
- 18 power watch code An electronic control board issue or supply interruption produces this code and power-cycling at the breaker for 30 seconds is the first step, but recurrence points to control board replacement.
- Microwave runs but no heat A failed magnetron, defective high-voltage diode, or bad capacitor stops microwave generation and requires testing and replacement of the faulty high-voltage component.
Parts That Commonly Fail
| Part | Notes |
|---|---|
| Cavity thermal sensor | Amazon | Most common failure, triggers F1 or F2 codes |
| Touch pad/control panel assembly | Amazon | Fails from moisture or membrane wear, causes F3 or F10 |
| Temperature probe assembly | Amazon | Open or shorted probe throws Probe or F6 code |
| Electronic control board | Amazon | Responsible for 18 power watch and persistent code issues |
Microwave Error Codes for This Model
These codes apply to this model line:
- Ge Microwave F1 error code
- Ge Microwave F10 error code
- Ge Microwave F2 error code
- Ge Microwave F3 error code
- Ge Microwave F4 error code
- Ge Microwave F5 error code
- Ge Microwave F6 error code
- Ge Microwave Pf error code
When to Call a Pro
Call a qualified appliance technician for any fault code that returns after sensor or probe replacement, for persistent 18 power watch errors that survive a power reset, or for no-heat conditions that involve the high-voltage circuit (magnetron, capacitor, diode, and transformer). High-voltage microwave components store lethal charge even when unplugged and require proper discharge procedures and metering. If you are not trained in high-voltage appliance work or do not have the tools to safely test and discharge capacitors, do not open the cabinet. Touch panel and control board replacement also requires careful connector work and ESD precautions, so professional service is recommended if you are unsure of the disassembly or part identification.