Electrolux Washer E13 Error Code — What It Means
E13 on Electrolux washers means the control has detected an unexpected drop in water level during the cycle. The machine believes water is leaving the tub when it should not, or the pressure-sensing system is giving incorrect feedback. This code points to either a real leak somewhere in the water path or a fault in the pressure circuit that monitors water level. Technicians approach E13 as a ‘water level not holding’ fault rather than a single-component failure.
Common Causes
- External or internal water leaks Loose or cracked fill hoses, torn door boot or gasket, leaking tub-to-pump hose, or loose hose clamps allow water to escape and trigger the level drop.
- Drain hose installed too low or siphoning A drain hose positioned below the tub waterline or otherwise allowing siphon flow mimics a leak and causes the same water-level fault.
- Pressure-sensor or pressure-hose fault A blocked, pinholed, disconnected, or water-filled pressure hose or a defective pressure switch gives false water-level feedback to the control.
- Faulty water inlet valve If the inlet valve does not fill correctly or cannot maintain steady flow, the tub may not hold the expected level and the control flags E13.
- Control board issue Less common, but the main PCB may misread pressure signals if all mechanical and sensor checks pass.
Step-by-Step Fix
- Unplug the washer and shut off the water supply if you see active leaking to make the machine safe.
- Inspect for visible water loss around the base, door boot, fill hoses, tub area, and pump area to confirm whether you have an actual leak.
- Check fill-hose connections at the inlet valves and verify the drain hose is properly positioned and not installed low enough to siphon water from the tub.
- Examine the door boot and gasket for tears, trapped debris, or loose clamps, and inspect the tub-to-pump hose path for leaks or pinched sections.
- Inspect the pressure-sensor circuit by checking the pressure hose for blockage, pinholes, loose fittings, or water inside the line, and test the pressure switch if accessible.
- Test the inlet valve operation by running a fill cycle and watching for abnormal fill behavior, and replace the valve if it does not fill steadily or leaks internally.
- Check wiring to the pressure sensor and control board, and consider the main PCB only after all mechanical water-path and pressure-sensing items test good, then clear power and run a test cycle to confirm the code is gone.
Parts Often Needed
| Part | Notes |
|---|---|
| Electrolux washer fill hose set | Amazon | Replace if inlet hoses are cracked, bulging, or leaking at fittings. |
| Electrolux washer door boot / door gasket | Amazon | Order the boot specific to your model if torn or leaking around the door seal. |
| Electrolux washer pressure switch and hose | Amazon | Replace if the air-hose circuit is damaged or the switch does not close at the correct water level. |
| Electrolux washer water inlet valve | Amazon | Needed when fill control is poor or the valve leaks internally and cannot maintain tub level. |
When to Call a Pro
Call a professional if you cannot locate any visible leak or drain-hose siphon issue and the pressure-sensor circuit tests good. Control-board diagnostics and internal tub inspection require model-specific service documentation and multimeter work. A technician can measure pressure-switch actuation points, test inlet-valve solenoid resistance, and verify wiring continuity to the main PCB. If you are uncomfortable working with water connections under pressure or removing cabinet panels to trace internal hoses, professional service will save you time and prevent flood risk.