Tag: washer
All the articles with the tag "washer".
-
Kenmore Washer Leaking Water - Causes & Fix
A cracked or worn drain pump is the most common leak source. Inspect the pump, tub-to-pump hose, and door boot seal, then replace the failed part.
-
Kenmore Washer Won't Spin - Causes & Fix
Usually a motor lock (LE code), drain blockage (OE code), or simple control glitch. Reset the machine, check for obstructions, and inspect the drain path.
-
Kenmore Washer Won't Drain - Causes & Fix
Usually a clogged pump filter or kinked drain hose. Clean the coin trap, check the hose for blockages, and test the drain pump for obstructions.
-
Frigidaire Washer Won't Fill With Water - Causes & Fix
Usually caused by closed supply faucets or kinked inlet hoses. Check that both hot and cold faucets are fully open and hoses are straight.
-
Frigidaire Washer Won't Turn On - Causes & Fix
Usually caused by no power at the outlet or a failed door latch. Check the breaker, outlet, and door lock first before replacing parts.
-
Frigidaire Washer Stops Mid Cycle - Causes & Fix
Usually a lid or door lock feedback problem. Check the latch for positive closure and test the lock assembly for continuity.
-
Frigidaire Washer Leaking Water - Causes & Fix
Most leaks come from loose or damaged inlet hoses and O-rings. Turn off water, inspect connections, replace worn gaskets, and check drain routing.
-
Frigidaire Washer Won't Spin - Causes & Fix
Usually a faulty door lock, lid switch, or door latch assembly prevents the spin enable circuit from closing. Test and replace the lock.
-
Frigidaire Washer Won't Start - Causes & Fix
Most often a tripped breaker, unplugged cord, or unlatched lid. Check power, door latch, and water valves before testing lock circuits.
-
Frigidaire Washer Won't Drain - Causes & Fix
Most likely a main control board relay fault (E23 code) preventing pump power, or a clogged pump/coin trap. Check pump circuit first.
-
GE Washer Won't Turn On - Causes & Fix
Usually no incoming power or control lock engaged. Check the breaker, outlet, and cord, then disable control lock and reset the machine.
-
GE Washer Shaking and Loud - Causes & Fix
An unbalanced load or washer not level is the most common cause. Redistribute clothes evenly and check all four legs are locked and level.
-
GE Washer Door Won't Unlock - Causes & Fix
Usually the door lock assembly has failed or the control is still waiting to drain. Unplug for 30 seconds, then run forced test 13.
-
GE Washer Won't Fill with Water - Causes & Fix
Usually a closed supply valve, kinked hose, clogged inlet screen, or failed water inlet valve. Check supply path first, then test the valve.
-
GE Washer Stops Mid Cycle - Causes & Fix
Usually an unbalanced load or control lockup. Reset by unplugging two minutes, level the washer, and redistribute the load evenly.
-
GE Washer Leaking Water - Causes & Fix
Most GE washer leaks come from a contaminated or damaged door gasket on front-loaders. Clean and inspect the seal and check hose connections.
-
GE Washer Won't Start - Causes & Fix
Usually caused by Control Lock being on, Delay Start enabled, or a door/lid not latched. Turn off lockouts and check the latch first.
-
GE Washer Won't Spin - Causes & Fix
Most often a stored fault code pointing to a bad lid switch, lid lock, or motor/inverter drive. Retrieve codes in service mode first.
-
GE Washer Won't Drain - Causes & Fix
Most often a clogged pump filter or failed drain pump. Clean the filter first, then test the pump in service mode and replace if needed.
-
Maytag Washer Won't Turn On - Causes & Fix
Usually a tripped breaker, unplugged cord, or control lock engaged. Check outlet voltage, reset the control lock, and power-cycle the unit.
-
Maytag Washer Shaking and Loud - Causes & Fix
Usually an unlevel washer or unbalanced load. Level the machine, redistribute clothes, and check suspension rods if shaking persists.
-
Maytag Washer Stops Mid Cycle - Causes & Fix
A Maytag washer stopping mid-cycle usually means a drain restriction, lid-lock fault, or unbalanced load. Check the drain hose first.
-
Maytag Washer Door Won't Unlock - Causes & Fix
Water still in the tub or Fresh Hold active. Press Cancel/Power, wait two minutes, then run Drain & Spin to empty the washer.
-
Maytag Washer Won't Fill With Water - Causes & Fix
Usually clogged inlet screens or a closed water valve. Check both hot and cold supply faucets are open, then clean the screens at the valve.