Tag: symptom

All the articles with the tag "symptom".

• Frigidaire Washer Won't Drain - Causes & Fix

  1 Jun, 2026

  Most likely a main control board relay fault (E23 code) preventing pump power, or a clogged pump/coin trap. Check pump circuit first.

• GE Washer Won't Turn On - Causes & Fix

  1 Jun, 2026

  Usually no incoming power or control lock engaged. Check the breaker, outlet, and cord, then disable control lock and reset the machine.

• GE Washer Shaking and Loud - Causes & Fix

  1 Jun, 2026

  An unbalanced load or washer not level is the most common cause. Redistribute clothes evenly and check all four legs are locked and level.

• GE Washer Door Won't Unlock - Causes & Fix

  1 Jun, 2026

  Usually the door lock assembly has failed or the control is still waiting to drain. Unplug for 30 seconds, then run forced test 13.

• GE Washer Won't Fill with Water - Causes & Fix

  1 Jun, 2026

  Usually a closed supply valve, kinked hose, clogged inlet screen, or failed water inlet valve. Check supply path first, then test the valve.

• GE Washer Stops Mid Cycle - Causes & Fix

  1 Jun, 2026

  Usually an unbalanced load or control lockup. Reset by unplugging two minutes, level the washer, and redistribute the load evenly.

• GE Washer Leaking Water - Causes & Fix

  1 Jun, 2026

  Most GE washer leaks come from a contaminated or damaged door gasket on front-loaders. Clean and inspect the seal and check hose connections.

• GE Washer Won't Start - Causes & Fix

  1 Jun, 2026

  Usually caused by Control Lock being on, Delay Start enabled, or a door/lid not latched. Turn off lockouts and check the latch first.

• GE Washer Won't Spin - Causes & Fix

  1 Jun, 2026

  Most often a stored fault code pointing to a bad lid switch, lid lock, or motor/inverter drive. Retrieve codes in service mode first.

• GE Washer Won't Drain - Causes & Fix

  1 Jun, 2026

  Most often a clogged pump filter or failed drain pump. Clean the filter first, then test the pump in service mode and replace if needed.

• Maytag Washer Won't Turn On - Causes & Fix

  1 Jun, 2026

  Usually a tripped breaker, unplugged cord, or control lock engaged. Check outlet voltage, reset the control lock, and power-cycle the unit.

• Maytag Washer Shaking and Loud - Causes & Fix

  1 Jun, 2026

  Usually an unlevel washer or unbalanced load. Level the machine, redistribute clothes, and check suspension rods if shaking persists.

• Maytag Washer Stops Mid Cycle - Causes & Fix

  1 Jun, 2026

  A Maytag washer stopping mid-cycle usually means a drain restriction, lid-lock fault, or unbalanced load. Check the drain hose first.

• Maytag Washer Door Won't Unlock - Causes & Fix

  1 Jun, 2026

  Water still in the tub or Fresh Hold active. Press Cancel/Power, wait two minutes, then run Drain & Spin to empty the washer.

• Maytag Washer Won't Fill With Water - Causes & Fix

  1 Jun, 2026

  Usually clogged inlet screens or a closed water valve. Check both hot and cold supply faucets are open, then clean the screens at the valve.

• Maytag Washer Leaking Water - Causes & Fix

  1 Jun, 2026

  Usually a loose or damaged hose connection. Check all fill and drain hoses for cracks, kinks, or loose clamps and tighten or replace as needed.

• Maytag Washer Won't Start - Causes & Fix

  1 Jun, 2026

  Control Lock is usually enabled or the lid isn't fully latched. Turn off Control Lock, close the lid firmly, and hold Start for 3 seconds.

• Maytag Washer Won't Spin - Causes & Fix

  1 Jun, 2026

  Most often caused by an unbalanced load or a faulty lid latch. Redistribute the laundry, make sure the lid closes fully, and retry the spin cycle.

• Maytag Washer Won't Drain - Causes & Fix

  1 Jun, 2026

  Usually a kinked or clogged drain hose. Check the hose for kinks, clogs, and correct standpipe installation before replacing parts.

• Whirlpool Washer Shaking and Loud - Causes & Fix

  1 Jun, 2026

  Usually caused by an unbalanced load or unlevel washer. Redistribute clothes evenly, adjust leveling legs, and tighten jam nuts.

• Whirlpool Washer Door Won't Unlock - Causes & Fix

  1 Jun, 2026

  Control Lock is usually on or the washer is still draining. Press and hold Control Lock for 3 seconds, or wait 5 minutes after the cycle ends.

• Whirlpool Washer Stops Mid Cycle - Causes & Fix

  1 Jun, 2026

  Usually caused by an unbalanced or overloaded load. Redistribute the laundry evenly in the drum and restart the cycle to clear the pause.

• Whirlpool Washer Won't Fill with Water - Causes & Fix

  1 Jun, 2026

  Usually a closed supply valve, kinked hose, or clogged inlet screen. Check water supply first, then clean screens and test the valve.

• Whirlpool Washer Leaking Water - Causes & Fix

  1 Jun, 2026

  Most Whirlpool washer leaks come from loose or damaged fill and drain hoses. Check all hose connections and washers at the back first.