Tag: appliance
All the articles with the tag "appliance".
-
Frigidaire Refrigerator Freezing Food - Causes & Fix
A Frigidaire refrigerator freezing food in the fresh-food section is usually caused by a damper allowing too much freezer air in or blocked vents.
-
Frigidaire Refrigerator Running Constantly - Causes & Fix
Dirty condenser coils or a stuck condenser fan motor usually cause constant running. Clean the coils and verify fan operation.
-
Frigidaire Refrigerator Leaking Water - Causes & Fix
Most often a clogged or frozen defrost drain. Flush the drain with warm water to clear debris and restore flow to the drain pan.
-
Frigidaire Refrigerator Water Dispenser Not Working - Fix
Usually a clogged or incorrectly installed water filter. Remove and inspect the filter, replace if damaged, and verify it seats properly.
-
Frigidaire Refrigerator Ice Maker Not Working - Causes & Fix
Most often the ice maker switch is off, the freezer is too warm, or the water filter is clogged. Check the switch, verify 0°F freezer temp, and replace the filter.
-
GE Refrigerator Not Cooling - Causes & Fix
Dirty condenser coils are the most common cause. Clean the coils at the back or bottom with a vacuum and brush to restore airflow.
-
GE Dryer Stops Mid Cycle - Causes & Fix
A blocked vent causes most mid-cycle stops by overheating the dryer. Clean the lint screen, duct, and exterior hood first.
-
LG Dryer Shuts Off Early - Causes & Fix
Dirty moisture sensors or a small load usually cause early shutdown. Wipe the sensor bars under the lint filter with a damp cloth.
-
Whirlpool Dryer Shuts Off Early - Causes & Fix
Usually caused by blocked vents or a dirty lint filter restricting airflow. Clean the lint screen, dryer vent, and exterior exhaust opening.
-
LG Dryer Won't Tumble - Causes & Fix
Broken or slipped drive belt is the most common cause. Check the belt condition and motor microswitch, then test motor and control signals.
-
Kenmore Washer Won't Start - Causes & Fix
Most Kenmore washers won't start because the lid or door lock assembly isn't engaging. Clean the strike, check alignment, and replace the lock if needed.
-
Frigidaire Washer Shaking and Loud - Causes & Fix
Usually caused by an off-balance load or poor leveling. Redistribute laundry, level the washer on all four legs, and check floor support.
-
Whirlpool Washer Won't Turn On - Causes & Fix
Usually a tripped breaker or unplugged cord. Check the outlet and breaker, then unplug for 5 minutes and reconnect to reset the control.
-
Samsung Washer Won't Start - Causes & Fix
Usually caused by Child Lock being on, the door not latching fully, or the cycle still draining. Check the control panel first.
-
Frigidaire Washer Door Won't Unlock - Causes & Fix
Usually the safety interlock is still engaged because water hasn't fully drained or the cycle is still active. Wait 1–3 minutes after stopping, then check for standing water and drain pump operation.
-
GE JNM7196SKSS Microwave Problems & Error Codes
F1 open thermal sensor from cavity overheating is most common. Power-reset and check sensor wiring, replace thermal sensor if open.
-
Samsung ME21DG6500SR Microwave Problems & Error Codes
SE key error is most common on this model, usually from moisture or a stuck touch panel. Clean the keypad or replace the control board.
-
LG MVEL2125F Microwave Problems & Error Codes
Control lock (LOC) is the most common display issue on the MVEL2125F. Hold STOP/CLEAR until LOC clears to unlock the control panel.
-
Samsung MS14K6000AS Microwave Problems & Error Codes
SE and C-d0 door-key errors are most common, usually caused by stuck touch keys or misaligned door switches-power reset first, then check keypad.
-
GE JES1072SHSS Microwave Problems & Error Codes
F3 touch pad shorted error is most common on this model, caused by a stuck or failed membrane keypad that needs replacement or cleaning.
-
Whirlpool WMC30516HZ Microwave Problems & Error Codes
Door-error messages are most common, usually from a failing latch or misalignment. Reset power first, then inspect the door system.
-
Panasonic NN-SN67KS Microwave Problems & Error Codes
H97/H98/H99 inverter codes are the most common faults on the NN-SN67KS, usually fixed by replacing the inverter board or magnetron.
-
LG MVEL2033F Microwave Problems & Error Codes
Door latch and interlock switch failures cause most DOOR errors. Clean latch area, check alignment, and replace the switch assembly if needed.
-
GE JVM6175SKSS Microwave Problems & Error Codes
F1 open thermal sensor error is most common, usually from a failed cavity sensor or loose wiring. Replace the sensor or repair the harness.