Your Frigidaire washer stopped with E10 on the display. The machine tried to fill with water but didn’t sense enough reaching the drum within the expected time. This is a water fill problem, and in most cases it’s fixable in about 10 minutes with no tools.
Quick Reference
| Code | Meaning | Severity | DIY or Call |
|---|---|---|---|
| E10 / E11 | Water fill problem | Low | DIY |
| E13 | Water leak / imbalance | Medium | DIY |
| E20 | Drain problem | Low | DIY |
What This Error Means
E10 means the pressure switch (or electronic pressure sensor) didn’t detect the correct water level after the inlet valves were opened. The washer fills for a period, checks the level, and if it’s too low, it assumes there’s a problem and stops with E10.
The issue is almost always on the water supply side — not the washer’s internal electronics. The machine is telling you it can’t get enough water, not that it’s broken.
Common Causes
- Water supply shut off — Someone turned off the hot or cold valve under the sink. This happens more often than you’d think.
- Kinked fill hoses — The rubber hoses from the shutoff valves to the washer are bent sharply, restricting flow.
- Clogged inlet valve screens — Tiny mesh screens inside the water inlet valves catch sediment. Over time they can clog, especially if you have hard water.
- Low water pressure — The washer needs at least 20 PSI to fill properly.
- Faulty water inlet valve — The solenoid that opens the valve has failed.
- Faulty pressure sensor — Rare, but the sensor that measures water level can fail.
Quick Reference
| Code | Meaning | Severity | DIY? |
|---|---|---|---|
| E10 | Water fill problem — not enough water detected | Moderate | Yes — check supply first |
Step-by-Step Fix
-
Check that both hot and cold water valves are fully open. Turn both shutoff valves under the sink counterclockwise until they stop. This is the number one cause of E10.
-
Inspect the fill hoses. Look along the entire length of both hoses from the shutoff valves to the back of the washer. Any sharp kinks are restricting water flow. Straighten or reposition the hose.
-
Run a test fill cycle. Set the washer to a normal cycle and start it. Listen for water entering the machine. If you hear nothing (valves not opening) or only a trickle (clogged screens), move to step 4.
-
Clean the inlet valve screens. Unplug the washer and turn off both water valves. Disconnect the fill hoses from the back of the washer (use a pan — water will drip). Inside the threaded connections on the washer, you’ll see small mesh screens. Use needle-nose pliers to gently pull them out. Rinse them under running water and scrub gently with an old toothbrush. Reinstall and test.
-
Check water pressure. Partially open a nearby faucet to confirm you have adequate household water pressure. If the whole house has low pressure, that’s a plumbing issue, not a washer problem.
-
Test the water inlet valves. If screens are clean and water is on but no water enters the machine, the inlet valve solenoids may have failed. Test each solenoid coil with a multimeter — you should see 500–1500 ohms across the terminals. Open circuit means the solenoid is dead.
Parts You May Need
- Frigidaire washer water inlet valve
- Washing machine fill hoses (braided stainless)
- Needle-nose pliers set
- Multimeter for appliance testing
When to Call a Technician
If you’ve confirmed the water supply is on, screens are clean, and hoses aren’t kinked but E10 persists, the inlet valve or pressure sensor needs replacement. Valve replacement is straightforward — one bracket, two hoses, and a connector. Pressure sensor diagnosis is trickier and may warrant a service call.