Posts

All the articles I've posted.

• GE Microwave F3 Error Code - Causes & Fix

  7 Jun, 2026

  F3 signals a shorted or faulty keypad (touchpad/membrane switch). Most commonly fixed by replacing the membrane keypad assembly.

• Whirlpool Oven F2 E0 Error - Causes & Fix

  7 Jun, 2026

  F2 E0 means a shorted or stuck keypad on your Whirlpool oven. The most likely fix is replacing the user interface/keypad assembly.

• Frigidaire Oven F10 Error Code - Causes & Fix

  7 Jun, 2026

  F10 means thermal runaway: the oven is overheating or heating when it shouldn't. Most often caused by a stuck relay on the control board.

• GE Oven F4 Error Code - Causes & Fix

  7 Jun, 2026

  F4 on a GE oven means the oven temperature sensor circuit is shorted or reading below normal resistance. Replace the sensor first.

• Frigidaire Range F10 Error Code - Causes & Fix

  7 Jun, 2026

  F10 means runaway oven temperature detected. The most common fix is replacing the failed oven temperature sensor (RTD).

• GE Oven F3 Error Code - Causes & Fix

  7 Jun, 2026

  F3 on a GE oven means the temperature sensor circuit is out of range. The sensor itself is the most common cause and the fix.

• GE Range F4 Error Code - Causes & Fix

  7 Jun, 2026

  F4 means the oven temperature sensor is open, shorted, or out of range. Most often the sensor itself has failed and needs replacement.

• GE Range F3 Error Code - Causes & Fix

  7 Jun, 2026

  F3 means the control sees the oven temperature sensor circuit as open or out of range. Usually fix by replacing the sensor.

• Whirlpool Dryer F22 Error Code - Causes & Fix

  7 Jun, 2026

  F22 means the control can't read the exhaust thermistor. Most often a failed thermistor. Replace it after testing resistance.

• Samsung Washer DC Error Code - Causes & Fix

  7 Jun, 2026

  DC means unbalanced load. Redistribute clothes evenly in the drum, check the washer is level, and remove any shipping bolts if new.

• Samsung Washer UE Error Code - Causes & Fix

  7 Jun, 2026

  UE means unbalanced load detected. Redistribute laundry evenly around the drum, then restart the spin cycle to clear the code.

• LG Washer UE Error Code - Causes & Fix

  7 Jun, 2026

  UE means unbalanced load during spin. Most often fixed by redistributing wet laundry evenly in the drum and leveling the washer's feet.

• Frigidaire Range F31 Error Code - Causes & Fix

  7 Jun, 2026

  F31 means the control board cannot read the oven temperature sensor. Most often a failed sensor probe causes it. Replace the sensor first.

• Frigidaire Range F30 Error Code - Causes & Fix

  7 Jun, 2026

  F30 means an open oven temperature sensor circuit. The most common fix is replacing the failed sensor or repairing its connector.

• GE Dryer E03 Error Code - Causes & Fix

  7 Jun, 2026

  E03 on a GE dryer means a thermistor temperature-sensing fault. Most often caused by a failed outlet thermistor or loose wiring.

• Samsung Oven SE/5E Error Code - Causes & Fix

  7 Jun, 2026

  SE or 5E on a Samsung oven means a stuck or shorted button on the control panel. Most often the membrane keypad needs replacement.

• Samsung Range 5E/SE Error Code - Causes & Fix

  7 Jun, 2026

  Samsung 5E/SE code means a stuck or shorted keypad button. Most likely fix: clean the control panel and reset power at the breaker.

• Samsung Washer 4C Error Code - Causes & Fix

  7 Jun, 2026

  Samsung 4C means the washer can't fill with enough water in time. Most common fix: clean the inlet hose mesh filters or open the tap fully.

• Samsung Range E-27 Error Code - Causes & Fix

  7 Jun, 2026

  E-27 on a Samsung range means the oven temperature sensor is open or not sending a valid signal. Replace the sensor (most common fix).

• Samsung 1C Error Code - Causes & Fix

  7 Jun, 2026

  Samsung 1C means water-level sensor fault. Most often a kinked or blocked pressure hose to the sensor. Check hose, clean connections.

• Samsung Refrigerator 4E Error Code - Causes & Fix

  7 Jun, 2026

  4E means the freezer defrost temperature sensor has failed. The most common fix is replacing the defrost thermistor clipped to the evaporator.

• GE Dryer E02 Error Code - Causes & Fix

  7 Jun, 2026

  E02 means outlet thermistor fault. Most likely loose wiring at sensor. Unplug dryer, check connections, replace thermistor if wiring OK.

• Whirlpool Dryer F25 Error Code - Causes & Fix

  7 Jun, 2026

  F25 is a temperature-sensing fault. Most often a failed thermistor or open thermal fuse. Reset power for 1 minute, then test.

• Samsung Refrigerator 2E Error Code - Causes & Fix

  7 Jun, 2026

  2E means fridge compartment temperature sensor error (open or short circuit). Replace the sensor or repair its harness connector.