Posts
All the articles I've posted.
-
LG Dryer Won't Tumble - Causes & Fix
Broken or slipped drive belt is the most common cause. Check the belt condition and motor microswitch, then test motor and control signals.
-
Kenmore Washer Won't Start - Causes & Fix
Most Kenmore washers won't start because the lid or door lock assembly isn't engaging. Clean the strike, check alignment, and replace the lock if needed.
-
Frigidaire Washer Shaking and Loud - Causes & Fix
Usually caused by an off-balance load or poor leveling. Redistribute laundry, level the washer on all four legs, and check floor support.
-
Whirlpool Washer Won't Turn On - Causes & Fix
Usually a tripped breaker or unplugged cord. Check the outlet and breaker, then unplug for 5 minutes and reconnect to reset the control.
-
Samsung Washer Won't Start - Causes & Fix
Usually caused by Child Lock being on, the door not latching fully, or the cycle still draining. Check the control panel first.
-
Frigidaire Washer Door Won't Unlock - Causes & Fix
Usually the safety interlock is still engaged because water hasn't fully drained or the cycle is still active. Wait 1–3 minutes after stopping, then check for standing water and drain pump operation.
-
A.O. Smith EEU6-50H45DV Water Heater Problems & Error Codes
Tripped high-limit cutoff causes most no-heat calls on this 50-gallon electric model. Press the red reset button on the upper thermostat.
-
Rheem XE40T06ST45U1 Water Heater Problems & Error Codes
Most common: red 4-blink code from tripped ECO or loose element wiring. Reset the high-limit switch and check element terminals for damage.
-
Rinnai V65iN Problems & Error Codes
Most V65iN units throw ignition codes (11, 12) from gas supply issues or dirty flame sensors. Check gas pressure and clean the flame rod first.
-
Bradford White RG250T6N Water Heater Problems & Error Codes
Gas valve faults (Code 7/8 flash) are the most common issue on the RG250T6N, typically requiring gas control valve replacement by a licensed tech.
-
Rheem XE50T10HS45U1 Problems & Error Codes
Wet rope sensor triggers false leak alarms on this 50-gallon ProTerra heat pump. Disconnect sensor from board, dry it, replace if needed.
-
Rinnai RUR199iN Problems & Error Codes
Code 11 ignition failure is most common, usually caused by closed gas valve, air in line, or low manifold pressure. Open gas supply first.
-
Rheem RTGH-95DVLN Problems & Error Codes
Code 11 ignition failure is most common, usually caused by gas supply interruption, flame rod fouling, or igniter failure requiring cleaning or part replacement.
-
Navien NPE-180S2 Problems & Error Codes
Ignition failure (E003) is the most common problem, usually caused by gas supply issues, dirty flame rod, or blocked venting.
-
Bradford White RG240T6N Problems & Error Codes
Seven or eight flashes on the gas valve indicate gas control failure. Replace the gas valve after verifying pilot flame and power supply.
-
A.O. Smith E6-50H45DV Water Heater Problems & Error Codes
Upper heating element failure causes most no-hot-water calls on this 50-gallon electric model. Check power and test the element first.
-
Rheem XE40M06ST45U1 Water Heater Problems & Error Codes
Most XE40M06ST45U1 units lose hot water from a tripped ECO or failed heating element. Reset the high-limit switch or test and replace the faulty element.
-
Rinnai RU199iN Water Heater Problems & Error Codes
Code 12 flame failure is the most common fault. Usually caused by gas supply issues, blocked venting, or a dirty flame rod that needs cleaning or replacement.
-
Navien NPE-240A2 Water Heater Problems & Error Codes
Ignition failure and flow sensor faults are the most common issues. Clean the intake air filter and check gas supply first.
-
Fujitsu ASU12RLF1 Problems & Error Codes
Communication errors from loose indoor-outdoor wiring are most common. Check terminal blocks, reseat connectors, and power cycle the system.
-
LG LAN120HSV5 Ductless Mini Split Problems & Error Codes
CH21 error code is the most common failure, caused by compressor overcurrent or inverter board faults requiring outdoor unit service.
-
LG LSU120HSV5 Ductless Mini Split Problems & Error Codes
CH 05 communication error is most common on LSU120HSV5, usually caused by loose interconnect wiring or defective indoor/outdoor PCB.
-
Daikin FTXV18AVJU9 Ductless Mini Split Problems & Error Codes
Communication errors (U4/U5 codes) are most common on this model, usually caused by loose wiring between indoor and outdoor units or at the remote controller.
-
LG LS120HSV5 Ductless Mini Split Problems & Error Codes
CH21 error (compressor overcurrent/IPM fault) is most common, caused by inverter PCB failure, compressor defect, or power supply issues.