Posts

All the articles I've posted.

• GE Refrigerator Thermistor Replacement - Signs & How-To

  1 Jun, 2026

  Wrong temps, frost buildup, or error codes mean a bad thermistor. Replacing the evaporator sensor restores accurate cooling and defrost cycles.

• Samsung Refrigerator Water Filter Replacement - Signs & How-To

  1 Jun, 2026

  Red filter light, slow water dispense, or bad taste mean your Samsung filter needs replacement. Installing a new HAF-CIN, HAF-QIN, or HAFCU1 cartridge and resetting the indicator restores clean water flow.

• Fujitsu Mini Split Not Cooling - Causes & Fix

  1 Jun, 2026

  Dirty air filters blocking airflow are the most common cause. Clean or replace filters, then check for error codes on the indoor LED.

• Daikin Mini Split Not Cooling - Causes & Fix

  1 Jun, 2026

  Usually caused by dirty indoor air filters or incorrect thermostat settings. Clean or replace the filter and verify cooling mode and setpoint.

• Mitsubishi Mini Split Not Cooling - Causes & Fix

  1 Jun, 2026

  Most often dirty air filters or blocked coils trigger protective shutdown. Clean filters, check fault code via failure mode recall, and inspect wiring.

• Rheem Furnace Igniter Not Working - Causes & Fix

  1 Jun, 2026

  Most often the igniter element has cracked or failed open. Test it with a multimeter at the leads for continuity and replace if open.

• Rheem Furnace Not Heating - Causes & Fix

  1 Jun, 2026

  A dirty flame sensor is the most common cause. Clean the sensor rod with fine steel wool or emery cloth and verify the gas valve is open.

• Trane Furnace Igniter Not Working - Causes & Fix

  1 Jun, 2026

  Usually a cracked or failed hot-surface igniter. Less often, bad wiring, a faulty control board, or a gas valve issue prevents ignition.

• Goodman Furnace Igniter Not Working - Causes & Fix

  1 Jun, 2026

  The igniter is likely failed and not glowing when voltage is applied. Verify the igniter receives 115–120 VAC during ignition.

• Carrier Furnace Igniter Not Working - Causes & Fix

  1 Jun, 2026

  The igniter is worn out or has failed. A technician replaces the igniter and verifies the ignition sequence completes normally.

• Whirlpool Microwave Buttons Not Working - Causes & Fix

  1 Jun, 2026

  Control Lock is usually enabled or the unit needs a power reset. Disable the lock or reset the breaker for one minute to restore function.

• GE Microwave Buttons Not Working - Causes & Fix

  1 Jun, 2026

  Usually a stuck program sequence or incomplete entry. Cancel any delay-start, power reset for 30 seconds, then test buttons again.

• LG Microwave Buttons Not Working - Causes & Fix

  1 Jun, 2026

  Child Lock is the most common cause. Hold START/ENTER for 4 seconds to unlock, then test. If still dead, power reset or service needed.

• Samsung Microwave Buttons Not Working - Causes & Fix

  1 Jun, 2026

  Control Lock is usually active or the panel is dirty. Turn off Control Lock per your manual, clean and dry the panel, then test.

• Samsung Microwave Won't Start - Causes & Fix

  1 Jun, 2026

  Most Samsung microwaves that won't start are stuck in Demo mode. Disable it in Options/My Settings, option 6, set to 2.

• KitchenAid Oven Self-Clean Not Working - Causes & Fix

  1 Jun, 2026

  Usually a failed thermal fuse or door lock problem. Check that the door closes fully and locks within 6 seconds of starting the cycle.

• KitchenAid Oven Igniter Not Working - Causes & Fix

  1 Jun, 2026

  A weak or failed igniter is the most common cause. Replace the igniter if it glows dimly, cracks, or won't spark the burner.

• KitchenAid Oven Broiler Not Working - Causes & Fix

  1 Jun, 2026

  Most often the door is not fully closed or the broil element has burned out. Check door position, then test the element for continuity.

• Frigidaire Oven Self Clean Not Working - Causes & Fix

  1 Jun, 2026

  Usually a failed door lock motor or latch switch. Check door closure, test lock assembly with a multimeter, then replace the faulty lock or control board.

• Frigidaire Oven Broiler Not Working - Causes & Fix

  1 Jun, 2026

  Most often a failed broil element (electric) or igniter (gas). Check for visible damage, test continuity, and replace the part.

• Frigidaire Oven Igniter Not Working - Causes & Fix

  1 Jun, 2026

  Most often a weak or failed hot surface igniter that no longer draws enough current to open the gas valve. Replace the igniter.

• Frigidaire Oven Won't Turn On - Causes & Fix

  1 Jun, 2026

  Most often a tripped breaker or lost power leg on electric models. Verify 240V at the outlet, then check the thermal fuse and control board.

• GE Oven Self-Clean Not Working - Causes & Fix

  1 Jun, 2026

  Usually the oven is too hot or the cycle wasn't set up correctly. Let it cool completely and follow your manual's exact steps.

• GE Oven Igniter Not Working - Causes & Fix

  1 Jun, 2026

  A weak or failed igniter is the most common cause. Replace the igniter if it glows but won't light the burner or shows no continuity.